EE 2231 Chapter : EE2231 Lab 10
Document Summary
To study the performance of some typical op-amp circuits. For all procedures, connect the figures in the lab manual and record the output using the scope. Procedures: (all figures are on page 4 of this report: comparator. (figure 1), apply a 1khz sine wave with a 1v p-p voltage. This graph was taken with 1 volt divisions and . 2sec divisions. Lab session #10 - operational amplifiers: follower (figure 2). It follows the square wave input just as it follows the sine wave. Lab session #10 - operational amplifiers: non-inverting amplifier (figure 3) follower (figure 2). Apply a 1khz sine wave with a 1v p-p voltage. The gain of the amplifier is approximately two. Change r2 between pin 2 and 6 to a 9k ohm resistor. Lab session #10 - operational amplifiers: inverting amplifier (figure 4). The gain of the amplifier is approximately -1. Lab session #10 - operational amplifiers: differentiator (figure 5)
