EE 2231 Chapter : EE2231 Lab8
Document Summary
Purpose: to characterize an npn bipolar transistor, and measure the dc operating point and the ac performance of a single transistor amplifier. Connect the circuit in figure 1, and use the potentiometer to vary the voltage at the input in 1v increments from 0 to 10v. Measure the voltage at the base and the collector. 2 without connecting the potentiometer, take voltage readings. Procedures: (all figures are on page 8 of this report: after assembling the circuit in figure 1 the following voltages were recorded. 736: after assembling the circuit in figure the following readings were recorded. Figure 2. with out the pot. in place. These readings were taken with the pot in place and adjusting it in . 1v increments. With the pot disconnected from figure 2, a 2v p-p sine wave was applied. 50mv divisions were used and 0. 2ms for time.
