47. Fill in the blanks in the table. Both AH and AS refer to the system. ΔH AS AG Low High Temperature Temperature + - Spontaneous + + II Temperature dependent + Spontaneous Nonspontaneous Nonspontaneous

word_media_image1.png

answers

watching

230

views

For unlimited access to Homework Help, a Homework+ subscription is required.

You have 0 free answers left.
Get unlimited access to 3.8 million step-by-step answers.

Get unlimited access

Already have an account? Log in

yoru5Lv10

18 Jun 2022

Unlock all answers

Get 1 free homework help answer.

Already have an account? Log in

You have 0 free answers left.
Get unlimited access to 3.8 million step-by-step answers.

Get unlimited access

Already have an account? Log in

Jamar FerryLv2

19 May 2018

Already have an account? Log in

Related questions

In a conductor carrying a current we expect the electron driftspeed to be:
Question 2 options:
a) much greater than the average electron speed
b) much less than the average electron speed
c) about the same as the average electron speed
d) less than the electron speed at low temperature and greater thanthe electron speed at high temperature
e) less than the electron speed at high temperature and greaterthan the electron speed at low temperature

QuestionDetails:

iii) For an endothermic reaction, what can you say abouttheequilibrium constant K1 measured at a low temperature T1withrespect to K2 measured at a high temperature T2?

_____ K1 < K2 _____ K1 = K2 _____ K1 > K2

iv) Typically, activity for a solvent is â¦

_____ pressure (P) _____ concentration (c) _____ molefraction(x)

i) As you heat water on the stove, bubbles start to form in thepanbelow the boiling temperature because gas comes out ofsolution.You can conclude that the enthalpy of dissolution of thegas isexothermic. - is it exothermic or endo????

v) Points A and B are separated by the very thin interfacebetweenthe air and liquid.

What can you say about the pressures at points A and B?

_____ PA < PB _____ PA = PB _____ PA > PB

thanks bluel ibra

Suppose that the three fundamental standards of the metricsystemwere length, density, and time rather than length, mass, andtime.The standard of density in this system is to be defined asthat ofwater. Which of the following are among the considerationsaboutwater that you would need to address to make sure that thestandardof density is as accurate as possible?

i) that the amount of water is at some defined value

ii)that the pressure of the water is at somedefinedvalue

iii)that the temperature of the water is at sdomedefinedvalue

iv)that the water is pure