ENGIN 25 Midterm: e25-fa2014-mt1-Anwar_Lieu-exam
Document Summary
The orientations of the x-y-z axes are to remain the same in all views. The figure below shows two pictorial drawings of the same object. The drawing on the left is the object as seen from the front/top/right-side, and the drawing on the right is the same object as seen from the rear/top/left-side. Sketch a mulit-view drawing of the object with sufficient orthogonal views and hidden lines to fully define the geometry of every feature. Center-lines and center-marks must be used when needed. Exact sizes are not required, but reasonably accurate proportions are expected. The figure below shows the front and right side views of a 3-dimensional object: on the figure below, add a correct top view. There is no need to add dimensions to the view, however, hidden lines, center-lines and center-marks must be included: create an isometric pictorial that shows the front, top, and right side views of the object.
